Guide · Homeowners · 4 min read · Updated 17 November 2026
How to Prepare a Hot Tub for Moving
Short answer
Turn off and isolate the power at the dedicated breaker, then drain the tub fully, ideally a day before the move. Remove filters, blow or vacuum water out of the pipework, and wipe the shell dry. Strap the cover on or remove it. Clear the route to the road, trim branches and measure gates. At the new address, have a level base and electrical supply ready before the crew arrives.
Isolating the power
Safety comes first. Before anyone touches the tub, switch it off at the control panel and then isolate it at its dedicated circuit breaker or isolator switch in the consumer unit or the outdoor isolator nearby. Hot tubs run on a high-current supply, and the combination of electricity and water makes this step essential. If you are not sure which breaker supplies the tub, ask an electrician to identify and isolate it.
Disconnecting the supply cable from the tub's control box is a job for a qualified electrician. The movers will not normally disconnect hard-wired electrical connections, and the electrical work at the new address should be carried out by a registered electrician, as installing a new circuit for a hot tub is notifiable work under Part P of the Building Regulations in England and Wales.
Draining the tub
Hot tub water is heavy, at roughly a kilogram per litre, and a typical tub holds well over a thousand litres. It must be completely drained before the tub can be tipped. Most tubs have a drain valve at the base of the cabinet; attach a garden hose and let it run to a suitable drain. A submersible pump is much faster. Allow several hours.
Take care where the water goes. Chemically treated water should not be drained onto lawns, flower beds or into surface water drains that lead to streams. Stop adding chemicals a few days before the move so levels drop, and drain into a foul drain such as an outside gully connected to the sewer where possible.
- Stop adding chemicals a few days before
- Isolate the power before draining
- Open the drain valve or use a submersible pump
- Drain to a foul drain, not onto plants or into streams
- Remove and clean the filters
- Wipe out remaining water from the footwell and seats
Clearing water from the pipework
Even after draining, water sits in the pipes, pumps and jets. When the tub is tipped, this water can run into the cabinet and onto electrical components. In cold weather, it can freeze and crack pipework. Blow out the lines with a wet and dry vacuum, working jet by jet, and leave the filter housing open to drain.
If the tub will be in storage or transit during freezing weather, getting the pipework as dry as possible is essential. Ask your mover whether they will do this as part of the job or expect it to be done beforehand.
Preparing the route
Walk the route the tub will take from its current position to the road. Measure the narrowest point, which is often a side gate, and compare it with the depth of the tub when tipped on its side. Remove gates from their hinges if needed, move garden furniture, pots and planters, and trim overhanging branches. If there are steps, tell the movers in advance so they bring ramps or extra crew.
If a crane lift is needed, think about what is between the tub and the road: overhead cables, trees, conservatories and roofs. Tell the movers about anything that could affect the lift plan.
| Check | Why it matters | What to do |
|---|---|---|
| Gate and passage widths | The tub must fit through on its side | Measure and remove gates if needed |
| Steps and slopes | Slow the move and need ramps | Tell the movers in advance |
| Ground conditions | Soft lawns make dollies sink | Lay boards or plan a firm route |
| Overhead obstacles | Affect crane lifts | Note cables, trees and roofs |
| Parking | The vehicle needs to be close | Reserve space outside both properties |
The cover and accessories
Hot tub covers are bulky and can blow off in the wind. Remove the cover and its lifter before the move, or strap it on tightly if the movers prefer to keep it in place. Steps, cover lifters, handrails and any furniture around the tub should be removed and moved separately. Check the cover for damage before the move, so you have a record.
Take photos of the tub from all sides before it is moved. If anything is damaged during the move, you have a clear record of its previous condition.
On moving day
Be around when the crew arrives so you can confirm the route, point out anything fragile and answer questions. The crew will check the tub is drained and isolated, remove any panels or steps still attached, and tip it carefully onto the dolly or sledge, strapping it in place. On soft ground they may lay boards to stop the wheels sinking. Keep children and pets indoors while the tub is moving, because a tipped hot tub is heavy and can be hard to stop on a slope.
At the new address, the crew wheels or lifts the tub onto its base, lowers it flat and checks it sits evenly. They do not normally connect the electrics, so arrange for your electrician to attend on the same day or soon after. Once connected, refill with fresh water, balance the chemicals, fit clean filters and run the tub through a full heating cycle while checking inside the cabinet for any drips from joints disturbed during the move.
Getting the new site ready
The tub should go straight onto its final position at the new address. That means a firm, level base strong enough to carry the full tub, usually a concrete slab or a properly designed deck, and an electrical supply installed and tested by a registered electrician to BS 7671, including the RCD protection required for hot tubs. Leaving these until after the move means the tub sits on grass or a driveway, or the crew has to come back.
Questions people also ask
How long does it take to drain a hot tub?
Using a garden hose on the drain valve, draining a typical hot tub takes several hours. A submersible pump is much faster, often under an hour. Allow time to blow out water from the pipework afterwards and to dry the footwell and seats before the movers arrive.
Do hot tub movers disconnect the electrics?
Not usually. Movers move the tub, but disconnecting and reconnecting the hard-wired supply should be done by a qualified electrician. Installing a new circuit at the new address is notifiable work under Part P of the Building Regulations in England and Wales.
Where should I drain hot tub water?
Drain it into a foul drain connected to the sewer, such as an outside gully, rather than onto lawns, plants or surface water drains leading to streams. Stop adding chemicals a few days before so levels drop, and check with your water company if you are unsure.
Written and checked by the Hot Tub Movers team. Read our editorial policy.
More guides
How Much Does It Cost to Move a Hot Tub in the UK?
Repositioning a hot tub within the same garden typically costs £200–£400. A local relocation with good access costs £350–£650, and a long-distance…
Hot Tub Crane Lifts: When You Need One and What It Costs
You need a crane lift when a hot tub cannot get through the garden on its side, usually because there is no side access wide enough. A HIAB…
Buying a Second-Hand Hot Tub: Checks and Collection
Before buying a second-hand hot tub, see it running and full of water, check for leaks, test the heater, pumps and jets, and inspect the shell,…
Hot Tub Removal and Disposal: How It Works and What It Costs
Old hot tub removal and disposal typically costs £250–£500. The crew drains and isolates the tub, removes it whole on a dolly or cuts it into…
Get a free hot tub movers quote
Tell us what you need and we'll come back with a clear price.
Request a quote