Hot Tub Movers

Hot Tub Movers

Swim Spa Moves

Relocation of swim spas, which are much longer and heavier than standard hot tubs and almost always need a crane.

Free Hot Tub Movers quote

No obligation. We only use your details to reply about this job.

Swim Spa Moves — Hot Tub Movers

What's involved

Swim spas are typically four to six metres long and can weigh between 1,000kg and 2,000kg empty, so they cannot be tipped and wheeled like a hot tub. Most moves need a mobile crane at each end and a low-loader or flatbed lorry for transport. The spa is drained fully, the electrics are disconnected by an electrician and any surround or decking is removed. Lifting is done with a spreader beam and strap set sized for the length, so the shell does not twist. The base at the new site must be a level reinforced concrete slab designed for the filled weight, which can be well over 10 tonnes. Planning usually takes a site visit at each end, a lift plan and sometimes road closures or parking suspensions. Expect a swim spa move to take a full day.

How we handle it

  1. Send details and photos

    Tell us the make, size and approximate weight of the tub, both addresses and the route out of the garden. Photos of the tub, gates, paths and any steps help us decide whether a crane is needed.

  2. Access check and quote

    We confirm whether the tub can be wheeled out on its side, needs panels or fences removing, or must be lifted with a HIAB or crane. You receive a clear quote covering the method and crew.

  3. Prepare the tub

    Drain the tub at least 24 hours before the move and have an electrician isolate and disconnect the supply. Make sure the new base is level, finished and cured.

  4. Move day

    The crew removes steps and cover, tips the tub onto a dolly or rigs it for a crane lift, transports it secured on its side and positions it on the new base.

  5. Level and hand over

    The tub is checked for level and full support. Your electrician reconnects the supply, then you refill, balance the water and check for leaks before heating up.

Price guide

Hot tub moves are priced on the size and weight of the tub, the access at both ends and the distance. A standard tub with wide side access is quick and simple. Crane lifts, swim spas, long carries and steps add equipment and crew, which increases the price.

  • Swim spa relocation: from £2,000. Mobile crane at both ends and flatbed transport; quoted after a survey.
  • HIAB crane lift: £450–£900 per lift. Lorry-mounted crane over a house or wall, depending on reach and weight.
  • Long-distance hot tub move: £650–£1,200. Priced mainly on mileage; access difficulties at either end cost more.

Questions about swim spa moves

How long before moving should I drain my hot tub?

Drain the hot tub at least 24 hours before the move. Even after the shell looks empty, water stays in the pipework, pumps and foam insulation, adding weight and potentially leaking during transport. Leave the cover off and drain plugs open where the manufacturer allows, so it can dry out as much as possible.

Do I need an electrician to move a hot tub?

Yes, a qualified electrician should isolate and disconnect the hot tub before it is moved, and reconnect it at the new location. Hot tubs usually run on a dedicated circuit with RCD protection. If a new circuit is needed at your new home, this is notifiable work under Part P in England and Wales.

Can a hot tub go through a side gate?

A hot tub can go through a side gate if the gap is wider than the tub's depth when tipped on its side, which is usually 90cm to 100cm. Allow extra room for the dolly and handlers. Measure tight corners, steps and overhanging obstacles too. If the route is too narrow, a crane lift is usually the answer.

Get a free hot tub movers quote

Tell us what you need and we'll come back with a clear price.

Request a quote